The combined wheel dehumidifier is divided into a treatment area and a regeneration area by a sealed system inside the dehumidification section, and the dehumidification wheel rotates slowly at a speed of 8-10 RPM to ensure that the entire dehumidification is a continuous process.
So, what maintenance needs to be done for the combined rotary dehumidifier?
1. The condenser should be cleaned frequently and kept clean
The inlet and outlet of the rotary dehumidifier shall not be blocked by obstructions, and the air filter net shall be cleaned. Clean the air filter regularly (about once every two weeks) to maintain the dehumidification, dust removal efficiency and service life of the machine. The air filter can be washed with water below 40℃. It is better to clean with detergent, wash off the dust, rinse with water, and put it back into the body after drying.
When cleaning the body, gently wipe with a wet cloth; Avoid direct water cleaning, so as not to destroy the electrical insulation, the body surface has adhesion, can be cleaned with soapy water, avoid to spray with gasoline, petroleum essence, solvent or spray insecticide, in order to avoid peeling paint or discoloration. Do not use thin rods and wire to cut the inside of the machine to avoid failure or danger.
2, the unit should be placed in the center of the room
Place should be flat, not inclined or sideways, to avoid machine failure or abnormal sound, after moving it is best to static pendulum four to six hours in advance, and then start to use, because the dehumidifier compressor pipeline contains cold coal, after moving, cold coal must be returned to the original position after four to six hours of time.
3, if the humidity in the air is below 30%, it is too dry and uncomfortable, so the reliable temperature and humidity controller is controlled to maintain it at 50%~60%. When in use, the doors and Windows are closed as much as possible to achieve good dehumidification effect in the room.
When the ambient temperature is lower than 15 ° C, the water droplets attached to the surface of the evaporator will freeze and the dehumidifier effect will be weakened, if the ambient temperature is more than 40 ° C, the pressure in the system will increase and the compressor will be overloaded, and the overload protector should cut off the line, otherwise the compressor motor will be damaged. Therefore, the dehumidifier is better used in the temperature range of 15 ° C ~40 ° C.
4, the water storage in the rotary dehumidifier is too full, in order to avoid overflow of dirty wetland surface, and must be carried in the operation of the body, please unplug the power cord plug, and then the water in the storage bucket.
5, power failure or long-term use, please unplug the power cord to maintain the machine life.
