Rotary dehumidifier belongs to an important branch of the field of air conditioning, is a typical representative of temperature control dehumidification, then, rotary dehumidifier need to do what maintenance?

1, the inlet and outlet of the rotary dehumidifier shall not be blocked by obstructions, and the air filter network shall be cleaned.

2, the rotary dehumidifier should be placed in the central position of the room.

3. The condenser should be cleaned frequently and kept clean.

4, if the humidity in the air is below 30%, it is too dry and uncomfortable, so the reliable humidity controller is controlled to maintain the range of 50% to 60%. When in use, the doors and Windows are closed as much as possible, so that the indoor dehumidification effect is achieved. The body should be placed flat, not tilted or horizontal, to avoid machine failure or abnormal sound.

5, when the ambient temperature is lower than 15 ° C, the water droplets attached to the surface of the evaporator will freeze and the dehumidifier effect will be weakened, if the ambient temperature exceeds 40 ° C, the pressure in the system will increase and the compressor will be overloaded, at this time the overload protector should cut off the line, otherwise the compressor motor will be damaged. Therefore, the dehumidifier is better used in the temperature range of 15 ° C ~ 40 ° C.

6, the water storage in the rotary dehumidifier is too full, in order to avoid overflow of dirty wetland surface, and must be carried in the operation of the body, please unplug the power cord plug, and then the water storage bucket.

7. The rotary dehumidifier regularly cleans the air filter network (about once every two weeks) to maintain the dehumidification, dust removal efficiency and life of the machine. The air filter can be washed with water below 40℃. It is better to clean with detergent, wash off the dust, rinse with water, and put it back into the body after drying.

When cleaning the body, gently wipe with a wet cloth; Avoid direct water cleaning, so as not to destroy electrical insulation. There is adhesive on the surface of the body, which can be cleaned with soapy water. Avoid spraying with gasoline, petroleum essence, solvent or spray insecticide to avoid peeling paint or discoloration. Do not use thin rods and wire to cut the inside of the machine to avoid failure or danger.

8, the rotary dehumidifier after moving it is better to static pendulum four to six hours in advance, and then start to use, because the dehumidifier compressor pipeline contains cold coal, after moving, cold coal must be returned to the original position after four to six hours of time.

9, power failure or long-term use, travel, please unplug the power cord to maintain the life of the machine.